Chemours

VITON™ A100

Fluoroelastomer (FKM) designed for use with Viton™ Curative No. 50. It is suitable for transfer & injection molding of complex shapes, such as gaskets. It is also used in extrusion, solution coating, fabric and tanks or chemical containers. It is an ultralow-viscosity, A-type gum dipolymer of hexafluoropropylene and vinylidene fluoride.Benefits:Demonstrates improved processing and rheology Provides increased mold flow, excellent mold release and good compression set resistance

VITON™ A361C

Fluoroelastomer (FKM) designed for compression, transfer & injection molding of O-rings & gaskets, valve stem and crankshaft seals. It is an incorporated cure A-family dipolymer of hexafluoropropylene and vinylidene fluoride plus cure chemicals and metal adhesion promoter. Benefits:Offers better metal adhesion along with the fluid and heat resistance characteristicsPossesses intermediate viscosity level and reduced curative levelOffers improved processing, increased mold flow and easier mold release with less mold foulingDisplays improved demolding hot tear and good metal bonding with standard industrial primers

VITON™ A200

Fluoroelastomer (FKM) designed for use with the clean molding bisphenol curative, Viton™ Curative No. 50. It is suitable for transfer & injection molding of O-rings, valve stem seals & shaft seals and parts with complicated shapes. It is also used in extrusion of fuel hose & tubing and solution coating of fabric and tanks or chemical containers. It is A-family gum dipolymer of hexafluoropropylene and vinylidene fluoride.Benefits:Demonstrates improved processing Provides lower viscosity, improved mold flow and excellent extrusion characteristicsOffers better mold release, less mold fouling and improved compression set resistance

VITON™ B50

Fluorinated hydrocarbon rubber (FKM). It is a vitan B polymer.

VITON™ B SHE

Fluorinated hydrocarbon rubber (FKM) grade.

VITON™ A201C

Fluoroelastomer (FKM) suitable for transfer & injection molding of O-rings, gaskets, seals, and other complex shapes. It is also used for extrusion of hose- & solid Fluoroelastomer (FKM) tubing and O-ring cord. It is an incorporated cure A-family dipolymer of hexafluoropropylene and vinylidene fluoride plus cure chemicals.Benefits:Possesses chemical and heat resistance characteristics Offers significant improvements in processing and rheologyProvides fully precompounded O-ring curative level, improved mold flow and easier mold releaseDisplays less mold fouling, low viscosity, ultrafast cure rate, excellent scorch safety and excellent compression set resistance